A pending swap on Ethereum is sped up by resending the same call from the same account at the same nonce with higher fees; nodes can replace the old transaction, and only one transaction at that nonce can be mined.
A Fee Replacement Wins by Reusing the Nonce
A swap can remain pending when its max fee falls below Ethereum’s current base fee or its effective priority fee is too low to attract a block builder. EIP-1559, introduced in the 2021 London upgrade, separates the base fee from the priority fee, or tip. The max fee caps their combined cost per unit of gas. Raising the tip helps only when the max fee also leaves room above the base fee.
The replacement happens in nodes’ pending transaction pools, before either swap executes. Geth defaults to a 10% replacement bump: both the new max fee and the new max priority fee must rise by at least 10% over the original values. Raise only one and a node holding the original can reject the new transaction as “replacement underpriced.” For original caps of 30 gwei and 2 gwei, set at least 33 gwei and 2.2 gwei, rounding upward where the wallet limits precision. A 10% bump clears that pool rule; choose a higher max fee if 33 gwei still won’t cover the current base fee and useful tip.
Resend the Router Call With Higher Fees
Resend the Fraxswap Router call at its pending nonce with higher fee caps. Have the pending transaction hash, its nonce, and enough ETH to cover the higher maximum gas cost. Use the wallet’s Speed up control when it preserves the original call; a custom transaction needs the same sender, Router destination, value, calldata, and nonce.
The signed swap call retains its deadline and minimum output when you change only its fees. Open Fraxswap to compare the current quote with the pending swap’s limits before paying to accelerate it.
-
Find the transaction on Etherscan and read its nonce, sender, fee caps, and pending status. These identify the transaction your replacement must displace.
-
Choose Speed up in your wallet, or prepare a custom transaction with the original Router call and nonce. The review screen should show the same swap details and sender.
-
Raise both max fee and max priority fee by at least 10%, rounding up. Compare the resulting max fee with the current base fee and your intended tip; the review screen should show a bid that can enter a block.
-
Sign and submit, then track both hashes on Etherscan. The task is done when the new hash is mined and the old one shows as replaced. Read the new transaction’s execution status to see whether the swap succeeded or reverted.
Fee replacement speeds inclusion, not the swap’s price terms. A moved price can put output below the signed minimum; an expired deadline can also make the faster transaction revert. Either failure consumes gas. The original may also be mined while the replacement propagates, so use the mined hash to establish what happened.
Related Questions
Why Is My Ethereum Transaction Stuck Pending?
A transaction stays pending when its max fee cannot cover the current base fee, its effective tip loses to competing bids, or an earlier nonce from the same account is waiting. Compare its fee caps with current conditions and inspect any lower pending nonce before replacing it.
How to Cancel a Pending Transaction on Ethereum?
Send a 0 ETH transfer to your own address from the same account at the swap’s nonce, with fee caps high enough to replace it. When that transfer is mined, it consumes the nonce and ends the pending swap instead of retrying it. Confirm which hash mined: the original swap can still win if it reaches a block first.